Headlight Assembly for Chevy C/K Series 1500 2500 3500 / Tahoe/Suburban/Silverado Crystal Headlamp w/Corner & Bumper Chrome Housing with Clear Lens（Black）Category: 1500 Bumper Cover ReplacementProduct Description:8 pcs. Includes: 1 X Pair of Headlights (Left + Right)1 X Pair of Bumper Lights (Left + Right)1 X Set of 4 Corner Lights (Left + Right)Compatible with:94 Chevrolet Blazer Full Size94-99 Chevrolet C150094-00 Chevrolet C250094-02 Chevrolet C350094-99 Chevrolet K150094-00 Chevrolet K250094-00 Chevrolet K350094-99 Chevrolet C1500 Suburban94-99 Chevrolet C2500 Suburban94-99 Chevrolet K1500 Suburban94-99 Chevrolet K2500 Suburban95-99 Chevrolet TahoeFits Models with Composite Headlights ONLYOEM Part Number:15034929, 15034930, GM2502101, GM2503101, 5976838Features:Tested In Simulated Rain/Humidity/ShockHigh quality aftermarket replacement headlightsProfessional installation is highly recommendedAll Lamps come without bulbs, Should be re-use original factory bulbs.The rated power for bulbs is 70W. Users will not be suggested to use bulbs whoes power is above 70W.Installation recommendations:Step 1: Consult a vehicle manual to find out which component needs to be removed to get access to the headlight assembly. Depending on the year, make, and model of the vehicle, the front grill may need to be removed. To remove the grille, you have to undo the screws or any fastener used to secure it.Step 2: Undo the screws, clips, or retainer springs that hold the headlight in place. You may have to use a flat-blade or Phillips screwdriver to remove any of these fasteners that are typically located at the top and bottom of the headlight.Step 3: Disconnect the wiring from the assembly. After the wiring is removed, you can now detach the headlight from the vehicle to replace it with a new one.Step 4: Fit in the new headlight assembly. Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.Step 5: Reconnect the wiring that was unplugged from the assembly.Step 6: Put back the grille and other components that you removed. Seal them back into place.Step 7: Test the new assembly. Switch on the headlights to see if they’re working. If not, then make some adjustments and check the manual.