Dumble 50 Amp RV Plug Replacement RV Plug Adapter RV Power Cord 50A 125V FemaleCategory: 15a 125v Straight AdapterREPLACE OLD PLUG ENDS: The Dumble | 50 Amp RV Receptacle End provides a convenient, safe method to replace existing plugs or build a new extension cord with 6AWG / 3C and 8AWG / 1C wire; For connecting a generator or other equipment to your RV, camper, trailer, or 5th wheelFITS YOUR APPLICATION: 50A 125/250V 3750W rating; 50 Amp receptacle has 1-inch (25mm) inside diameter (ID) hole allows a secure fit for 10 AWG and 8AWG (3C/1C) wire; Perfect for most 50A RV vehicles and equipment (check your application ratings to ensure exact fitment and compatibility)COMFORTABLE TO UNPLUG: 50 Amp adapter includes an ergonomically-designed handle for easier finger grip and unpluggingBUILT TO LAST: Constructed from ABS plastic with conductive copper internal parts, this generator plug RV power adapter is made for maximum strength and longevity; TT-30P 50 Amp RV adapter with inner strain relief clip and outer bushing to firmly secure cable; Water resistant, not waterproofCHOOSE YOUR PACKAGE: Choose between a male or female end 50 Amp generator adapter to best suit your needs; Both RV power cord adapters come with step-by-step instruction guide included for plug replacement and installationYou need a safe and convenient method to replace plugs or build a new extension cord. The Dumble | 50amp RV Plug is your solution. With this 4 prong generator plug 50 AMP adapter in hand, remove original cord end, strip outer jacket end by 3.9-inch (100mm), cut black and red wire so it protrudes 2.2 inches (55mm) from the jacket, cut the white wire so it protrudes 1.4 inches (35mm) from the jacket, strip 0.5 inches (12mm) of all colored conductor cables. Loosen 3 holding screws from face of plug and remove cover. Loosen 2 strain relief screws enough to accept the cord and jacket. Slide cord through until edge of stripped cable is protruding through strain relief clip opening. Tighten strain relief, replace handle (make sure it is on the back side of the tang), and replace the cover.