Taillights Tail Lamps For Toyota Pickup Truck 1989 1990 1991 1992 1993 1994 1995 (Black Smoke Replacement Assembly Sold in Pairs)Category: 1991 Toyota Pickup SpecsDescription:Driving in the nighttime is a pretty tricky experience, especially if you have your tail lights broken or not working properly. The consequences of such traveling can be more than sad for both a driver and their passengers. To avoid any possible accidents caused by non-functioning tail lights, do replace them once the time comes. Upgrade your vehicle with a new, highly efficient set of AUTOSAVER88 lights and feel more confident than ever by informing other drivers whether you're about to turn or stop. And when the night comes calling, you will be ready to start your way.Specification:Quantity Sold: Set of 2Bulb Type: With P21W-12V / P21/5W-12V bulbs includedStreet Approve: DOT/SEA approvedColor Finish: Black housing w/ smoke lensLocation: Mounts using factory mounting locationsProduct Fit: CAD designed to provide a perfect, factory type fitWeather Sealed: Completely weather sealed to keep the elements outReplaces Original (OE) Part #: TO2800105, TO2801105, 81550-89166, 81560-89166Fitment:Toyota Pickup Truck 1989 1990 1991 1992 1993 1994 1995Package Include:1 Pair Tail Lights (Left & Right Side)Things you'll need:1. Trim panel removal tool, socket wrench, or screwdriver (depending on the fasteners used in the assembly)2. Tail light assembly that matches your vehicle's specsInstallation:Step 1. Remove the old tail light. First thing you have to do is undo the mounting screws on the outside, if there’s any. You’ll have to open the trunk or any rear door or opening on the vehicle to access the back of the tail light. The wiring harness must be disengaged from the assembly through its back. Once the wiring harness is out, you can now undo the mounting screws or nuts, whatever fastener is used. With no more screws or nuts holding it in place, you can push out the assembly from behind.Step 2. Check if the tail light assembly you just removed is the same as the new one. See if they have the same components, design, and fasteners to ensure proper fitting.Step 3. Fix the new assembly into the tail light pocket. Once it’s fitted into place, secure it with the screws or nuts. Tighten them properly. You can now plug in the wiring harness that you removed earlier.Step 4. Test the new assembly. Switch on the tail lights to see if they work. If not, then some adjustments should be done to the newly installed tail light kit.Step 5. Put back any cover, trim, or component that was removed to access the tail light assembly.