Clear Amber LED Turn Signals License Plate Tag Surface Mount Indicators BlinkersCategory: 2001 Clear Led1 Pair - Amber LED Universal Turn SignalsClear Lens - Surface Mount - Ultra Bright LEDsThese Universal LED Indicators can be used to supplement or replace your OEM Turn Signals though they are not OEM direct fitment lights. These Blinkers are a universal fit and can be installed on the front or rear with little or no modification to the fairing, depending on your selected mounting point. The low profile, arrowhead design can be mounted on the corners of your license plate or oriented to point directly to the direction you want to turn. E-Mark Stamped and Certified.Stats:Pair: 2 Signals =1x Left Side and 1x Right SideDimensions: Multiple, Please see pictures for approximate measurementsLens: Clear High Impact PlasticLEDs: 16 Amber Light Emitting DiodesHardware: Steel Mounting Bolt, Nut, and Lock WasherWiring: Two Wire, 12VDC Systems, wire length approximately 10 inches (25mm)Fitment: This is a Universal Turn Signal; therefore, will fit virtually any vehicle with little or no drilling on your plastics. This includes but is not limited to: Sportbikes, Cruisers, Scooters, ATV, UTV, MX, Dirt Bike, Enduro, Dual Sport, Golf Carts, and even 12VDC Snowmobiles.NOTE: This is an LED Turn Signal and can increase the flash rate of your blinkers. Flash Controllers (resistors or relays) are not required, but are recommended if you want to correct this hyper flashing condition.Install Notes: Always test the lights before installation to ensure they work properly. After testing we recommend disconnecting the battery prior to starting installation. Once you have chosen your mounting location, locate the existing Turn Signal wires on your bike. You should have either a 3 wire, or 2 wire system. If you have a 3 Wire System, your Running Light wires will not be used for this installation as these lights are not designed for that application. Proceed to instructions for2 wire systems. For a 2 Wire System attach our Yellow Signal wire to your bikes Positive Signal Wire, and our Black Signal Wire to your bikes Negative Signal Wire. Test the function of the light before replacing any removed parts. Repeat for the other side, reassemble, ride, and enjoy!