Gold Twist Motorcycle Hand Grips Bar Ends 7/8 Handlebar GSXR 600 750 1000 1300 HayabusaCategory: 750 Gsxr 20061 Pair - Gold Anodized Universal CNC Motorcycle Hand GripsThrottle and Clutch Grips - Attached Bar Ends - 7/8 Inch (22mm) Handlebars These Universal Grips are made of a strong, durable rubber that increases grip, reduces vibration, stands up to constant abuse, and are treated to reduce UV damage. Add these OEM Replacement Handlebar Grips with attached Bar Ends to your bike and ride in comfort and style! Stats:Pair: 1x Right Side Throttle Grip and 1x Left Side Clutch GripDimensions: Multiple, please see photo(s) for approximate measurementsGrip Inner Housing: Black Rubberized with Compression FitGrip Outer Housing: Gold Anodized CNC Billet AluminumBar Ends: Gold Anodized and Silver Anodized CNC Billet AluminumFitment: 7/8 Inch Diameter OEM or Aftermarket HandlebarsFitment Information: Our Hand Grips are Universal; therefore, can be used on all types of Powersport Handlebars: Sportbikes, Cruisers, Cafe Racers, Bobbers, Choppers, Scooters, ATV, Quad, MX, Dirt Bike, Enduro, and Dual Sport. Install Notes: When you open the package you will notice that one grip has a larger inner diameter than the other. The larger inner diameter grip is for the Throttle side (right side), while the smaller inner diameter is for the Clutch side (left side). Remove your old grips from the handlebar. Then clean all of the glue and dirt residue from the throttle plastic and the handlebar. Some Throttle tubes have a little ridge sticking up that may have to be cut and/or sanded down for proper installation. You will not use glue to install our hand grips because they are designed with a compression fit. To slide them on easier, we recommend using warm soapy water or glass cleaner; these liquids will evaporate upon drying. Do not use petroleum based lubricants as they will leave a slick residue, allowing the grip to slide off easily while riding. Do not use compressed air or a screwdriver to install as this could result in blowing out the side or damaging the graphics. Once applied and you're happy with them you may want to install Bar Ends. If the grips are open end, simply install your choice of Bar End. If the grips are closed end you will have to modify the grips by cutting the end out; by modifying you void warranty. To Start we recommend using a sharp X-Acto knife and with the grips installed, simply cut the end out using the inner wall of the Handlebars as a guide. Additional trimming may be required to facilitate proper Throttle Control with Bar Ends installed.