ABN | Inner Tie Rod Tool Kit – Inner Tie Rod Removal Tool Set with CrowfeetCategory: Inner Tie Rod RemovalMAKE SIMPLE AND QUICK ADJUSTMENTS: Use the ABN® Tie Rod Removal Tool Inner Tie Rod Puller Tool to save time by adjusting those hard-to-reach tie rods without removing the rack and pinion; Designed for steering repairs and front-end work where access is limited, this tie rods removal tool works with your hand wrench or rounded socket ends (not included); Not designed for use with power toolsFITS YOUR VEHICLE: Compatible with most Chrysler, Ford, and GM along with any vehicle tie rods that correspond to the included crowfeet sizes; Measure the inner tie rod rack end tool point (width of base above thread on new tie rod end) and compare to open jaw driver size options in your kit; Not for Saginaw type rack and pinion assembliesEASILY REMOVE AND ADJUST YOUR INNER TIE RODS: Fit one of the open-jaw driver pieces over the inner tie rod then slip the 20-inch (50.8 cm) long tie rod tool removal sleeve over the tie rod and connect it to the crowfoot; Take your time fitting the rack end removal tool tie rod kit on properly then use a 1/2-inch breaker bar to loosen or torque downCONVENIENT STORAGE: Heavy-duty 3.5 x 7 x 21.5-inch (8.9 x 17.8 x 54.6 cm) plastic blow-molded storage case for easy transportation, safe storage, and quick organization; Take these automotive tools tie rod removal tool kit with you anywherePACKAGE CONTENTS: Inner tie rod removal kit includes a rapid slide collar, (7) crowfeet hex clip tools (SAE - 1-3/16”, 1-1/4”, 1-5/16”, 1-7/16; Metric – 14mm, 17mm, 33.6mm), and a carrying case for your convenience; Use on a level surface with sturdy jack stands, a functional E-brake, rear chocks (4 are safer than 2), and hand glovesWhen the steering wheel on your vehicle starts to shake or feels loose, it is time to replace the tie rod ends to restore stability and security. Quickly and easily finish the job with the ABN® Inner Tie Rod End Tool Kit. This tie rod end removal tool set helps you to easily access hard to reach tie rods without having to remove the rack and pinion. Measure the inner tie rod point to select the correct size open-jaw driver crowfoot then attach the driver over the tie rod and slip the tie rod tool remover sleeve over the tie rod. Use a 1/2-inch breaker bar or hand wrench (not included) with the universal inner tie rod tools to loosen the tie rod. ABN inner tie rod tool not for use with Saginaw type rack and pinion assemblies and not intended for use with power tools.