Fog Lights 9006 12V 51W Halogen Lamp for 03-08 Toyota Matrix/ 03-08 Pontiac Vibe / 04-10 Scion TC One Pair of Right and Left Clear Glass Lens Fog LampsCategory: Matrix VibePoor visibility of the road caused by heavy snow, rain, or thick fog is a quite dangerous thing because of possible car accidents. Most drivers would rather stay at home than travel in such severe conditions, but what if you do have to drive your way despite the weather? With their incredible line of fog lights, AUTOSAVER88 makes it possible for every vehicle to continue its path no matter how miserable the conditions are. The parts offer both maximum driving safety and neck-braking design everyone is craving for. These lights will enable you to see the road ahead with an impressive amount of clarity, giving off spectacular illumination that is extremely stylish as well.Specification:Quantity Sold: Set of 2Bulb Type: 9006 12V 51WSwitch Wiring Harness: includedSurface Finish: Black housing w/ clear glass lensLocation: Mounts using factory mounting locationsProvide crisp, clear vision in rain, fog, and snowWeather Sealed: Completely weather sealed to keep the elements outReplaces Original (OE) Part #: 116-59636R, 8121001011, 88969944, 88973636, TO2593116, 11019233, T6993A/EEFitment:2003-2008 Toyota Matrix 2003 2004 2005 2006 2007 2008(Does Not Fit 07-08 Matrix XRS) 2003-2008 Pontiac Vibe 2003 2004 2005 2006 2007 2008 2004-2010 Scion tC with PT413-21050 Grill Package Include:1 Pair Fog Lights (Left & Right Side)Note:Most vehicles have a hole in the firewall pre-drilled at the factory for the purpose of running wires from under the hood to the interior.Installation:1. Closely check your existing fog light assembly.2. Remove the wiring harness from the fog light assembly.3. Take out the mounting screws of your old fog light assembly. These screws are normally found at the back of the fog light assembly.4. Take out the fog light assembly from your automobile.5. Get your new fog light and install it on your vehicle using the mounting screws that you removed earlier.6. Tighten the mounting screws just enough to keep your new fog light assembly securely installed. Be careful not to tighten the screws too much or they might cause damage to the assembly.7. Get the wiring harness connected to your new fog light assembly.8. Switch the fog lights on to see if they are working properly.